This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
hardware:d-link:dir-506l [2022/02/17 05:03] – root | hardware:d-link:dir-506l [2022/02/23 03:00] – root | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== D-Link DIR-506L ====== | ====== D-Link DIR-506L ====== | ||
+ | is a portable router with battery.\\ | ||
+ | {{: | ||
===== Hardware ===== | ===== Hardware ===== | ||
* Ralink RT5350 id:1 rev:3 (360 MHz) | * Ralink RT5350 id:1 rev:3 (360 MHz) | ||
Line 35: | Line 37: | ||
==== Power usage ==== | ==== Power usage ==== | ||
- | With Huawei | + | With [[hardware: |
* 240mA IDLE | * 240mA IDLE | ||
* 600+mA at download speed 5mbps | * 600+mA at download speed 5mbps | ||
- | Over 4 hours with 3 connected clients. | + | \\ |
+ | Uptime: ~4 hours with 3 connected clients. | ||
===== Photos ===== | ===== Photos ===== | ||
- | {{: | + | {{: |
- | {{: | + | {{: |
Line 50: | Line 53: | ||
===== Modding ===== | ===== Modding ===== | ||
==== Power ==== | ==== Power ==== | ||
- | To allow work without battery add resistor 15-16kOmh | + | To allow work without battery add resistor 15-16kOmh\\ |
- | {{: | + | {{: |
+ | ==== Micro USB ==== | ||
+ | {{: | ||
+ | ==== Headsink ==== | ||
+ | {{: | ||
+ | {{: | ||
===== OpenWRT ===== | ===== OpenWRT ===== | ||
Line 69: | Line 77: | ||
==== Installation ==== | ==== Installation ==== | ||
Apply factory image via http web-gui or JBOOT recovery page | Apply factory image via http web-gui or JBOOT recovery page | ||
+ | |||
+ | |||
+ | ==== Download ==== | ||
+ | [[http:// | ||
+ | |||
+ | |||
+ | ==== Known issues ==== | ||
+ | |||
+ | === Upgrade hang === | ||
+ | Upgrade may hang, at least then WebUI used.\\ | ||
+ | Workaround: stop unbound and dnsmasq before upload f/w to release memory. | ||
+ | |||
+ | |||
+ | === Net hang on boot === | ||
+ | Happen then internal switch exist and disabled.\\ | ||
+ | < | ||
+ | [[https:// | ||
+ | [[https:// | ||
+ | Workaround: unplug net cable untill device started\\ | ||
+ | Workaround: remove switch from existing configuration or build f/w without defined switch in 02_network and reset config on/after update | ||